Excell PWZ0163100.02 Guía para resolver problemas Pagina 8

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 113
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 7
101-3171Copyright © 2011 MAT Industries, LLC
8 - ENG
OPERATING INSTRUCTIONS
SAVE ALL INSTRUCTIONS
Compare the illustrations with your unit to familiarize yourself with the location of various controls and adjustments.
Save this manual for future reference.
BASIC ELEMENTS OF A
PRESSURE WASHER
High Pressure Pump (located inside the shroud,
not shown): Increases the pressure of the water sup-
ply.
Engine: Drives the high-pressure pump.
High Pressure Hose: Carries the pressurized water
from the pump to the run and spray wand.
Spray Gun: Connects with spray wand to control
water ow rate, direction, and pressure.
Chemical Hose: Feeds cleaning agents into the
pump to mix with the water. See How To Apply
Chemicals/Cleaning Solvents instructions in this sec-
tion.
Quick Connect Nozzles: Allow the user to quickly
and easily change the degree of spray to t the job
at hand.
BASIC ELEMENTS OF AN ENGINE
Refer to the engine manual for location and operation of
engine controls.
Choke Control: Opens and closes carburetor choke
valve.
Starter Grip: Pulling starter grip operates recoil starter to
crank engine.
Engine Switch: Enables and disables ignition system
Quick Connect Nozzles
stored in this panel
High-Pressure
Hose
Chemical
Hose
Engine
Spray Gun
PRESSURE WASHER TERMINOLOGY
PSI: Pounds per Square Inch. The unit of measure for water pressure. Also used for air pressure, hydraulic pressure, etc.
GPM: Gallons Per Minute. The unit of measure for the ow rate of water.
CU: Cleaning Units. GPM multiplied by PSI. GPM x PSI = CU
Bypass Mode: Allows water to re-circulate within the pump when the gun trigger is not pulled.
CAUTION
Allowing the unit to run for more than two minutes without the gun trigger pulled could cause overheat-
ing and damage to the pump.
Chemical Injection System: Mixes cleaners or cleaning solvents with the water to improve cleaning effectiveness.
Water Supply: All pressure washers must have a source of water. The minimum requirements for a water supply are
20 PSI and 5 gallons per minute.
Vista de pagina 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 112 113

Comentarios a estos manuales

Sin comentarios